Lead-free Compatible OSPs: What Does This Really Mean?

Reading time ( words)

Introduction

The setting: Early 2008. Many fabricators and EMS providers are continuing to push programs for RoHs compliance. This, of course, requires electronic assemblies to be, among other things, free of lead-bearing materials. To adopt such a program, the surface finish, component finish and the solder used in assembly must be lead-free. While the questions surrounding these issues are many, one in particular appears more frequently: How do we know that a particular finish is truly lead-free soldering compatible? This particular question is being addressed by one of the IPC standards writing committees responsible for developing an industry standard specification of organic solderability preservatives (OSP).

The Nature of the Beast

The IPC committee made up of a cross-section of suppliers, PWB fabricators, OEMs and EMS companies is working to complete the development of IPC-4555 (standard for OSP). This committee is developing a protocol to test OSP coatings for lead-free (high-temperature) compatibility. The protocol requires that copper coupons coated with the OSP would be subjected to three lead-free reflows, then tested for wettability with an appropriate wetting balance instrument. It should be noted that after the coupons are processed through the OSP solution, the coupons shall be rinsed with DI water and dried at 105°C. Following the protocol of the ANSI-JSTD-003B, the samples shall be fluxed using the standard 0.5% activated flux and immersed in SAC305 at a temperature of 255°C for 10 seconds. Further:

• Ten samples per test shall be run.
• The mean and standard deviation of the maximum force achieved shall be documented.

Interestingly, the committee has also recommended that a second set of test coupons be processed under the same pretreatment conditions. This time, however, without the drying step. Again, the ANSI-JSTD-003B, wetting balance procedure to measure wettability, will be utilized.

Read the full column here.


Editor's Note: This column originally appeared in the November 2014 issue of The PCB Magazine.

03/16/2023 | Pete Starkey, I-Connect007

Widely believed to be the traditional Centre of England, Meriden was a popular venue for a gathering of the UK printed circuit community this month. They braved the forecast of heavy snow for the Institute of Circuit Technology’s annual general meeting to learn about current developments and challenges in a thought-provoking technical seminar and to network with industry peers and contemporaries. Thankfully, the forecasted heavy snowfall did not reach Meriden until after the event; we only had a few flurries, although the weather caused considerable disruption elsewhere in the country.

03/15/2023 | Patty Goldman, I-Connect007

As a young industry professional, Paige Fiet, a process engineer at TTM Logan, sees mentorship as a formative component of her success in IPC. Alongside the support and guidance of her mentors, Paige has distinguished herself as an emerging leader who brings a fresh perspective to the many topics currently of interest to the industry.

03/13/2023 | Pete Starkey, I-Connect007

The IPC APEX EXPO Special Session on Advanced Packaging this year attracted enormous interest, with Conference Room 2 at capacity long before the session began. Even with lots of extra seats squeezed around the edges, the session was standing room only for the just-in-time arrivals. IPC Chief Technology Officer Matt Kelly opened proceedings by introducing a distinguished panel of experts: Jan Vardaman, president and founder of TechSearch International; Sam Salama, CEO of Hyperion Technology; Matt Neely, director of process engineering at TTM Technologies; and Jim Fuller, VP of engineering technology at Sanmina.